I3 Loadware Notes: 6/24/99

2.0.9 Fixes bug in 2.0.8 and earlier 2.x.x:
	If data and in-line commands are both buffered when
	a bypass RESUME command is received, processing on that
	port could stop.

2.1.0 Fixes bug in 2.0.9 and earlier 2.x.x:
	Hot key timeouts were not handled properly. When the
	timeout expired, accumulated data was buffered for
	the driver but was not sent; also, data was not
	flushed from the hot-key accumulation buffer.

2.1.1 Adds support for soon-to-be-released IntelliPort Plus
	ISA-4 card with 10-pin RJ45 connectors.
	(The ARR value for this board is 15H, indicating a
	four-port board with full data-set signal support.
	Earlier versions of the loadware do not correctly
	identify this as a valid value and will cause the board
	to halt with a fatal LED error code 28.

Compatibility notes:
	The IntelliPort Plus ISA-4 is scheduled for release
	later this year. To support this board, drivers must
	incorporate loadware version 2.1.1 or later.

	Diagnostic tip: 
	If drivers with earlier loadware are used, the 
	IntelliPort Plus ISA-4 will halt with a fatal LED error #28.